Single Lever Top Mount Outboard Marine Boat Engine Control Handle. 1 x Single Lever Engine Control. 1 x Set Mounting Hardware. All types of boats with outboard, inboard or I/O power, gas, or diesel. All 33C style and other engine control cables. This Is Aftermarket Replacement Item But Not Genuine. 1 All dimensions are measured by hand, there may be small deviations. 2 Color may vary slightly due to the color setting of each individual monitor. 1 According to the original factory specifications. 2 Perfect match for the original one. 3 Dual action, throttle and shift in one lever. Operate both throttle and shift for 1 engine. 4 Great for any type of boat with outboard, inboard or I/O power, gas or Diesel, very smooth shifting and throttle. 5 Pull-out handle disengages shift for throttle only warm-up. 6 The boat throttle has smooth shifting and throttling to be labor-saving and to lower the difficulties to operate. It uses built-in friction to avoid throttle creep. 7 The control system is mainly used for yachts, fishing boats and other water vehicles throttle and gear control, using a single handle to achieve control of the throttle and gear. 8 The neutral position is done by pulling out the hand levers 30 degree. Open the throttle Step As Follows. 1 Remove the lever. 2 Unlock the throttle and pull the flexible shaft. 3 Remove the swivel bracket. 4 Loosen the two (2) hex head screws at the link mechanism and remove the linkage. Make sure that the shift arm engagement teeth position is not changed. 5 Push the throttle arm toward the housing and rotate it 180 degrees until it bounces back. 6 Use the hex head screw to fasten the connecting rod mechanism to the desired position. 7 Insert the swivel bracket into the appropriate hole. 8 Re-install the push-pull flexible shaft and handle bar. 2022 à 01:12:30 CET, le vendeur a ajouté les informations suivantes.